CHEWING GUM REMOVAL

  • Use wire detail brush or nylon for carpets.
  • Heat up spot of gum for 1-3 seconds, release small amount of approved Gum remover using the chemical injection facility or pre spay the spot.
  • As the chemical hits the gum, scrub for few seconds and gum will dissolve.

Removing Wax, Tar etc.

Comment: Many stains are only stuck on the surface of materials and can be quickly removed by ‘blowing’ excess material away from the surface from the side. This prevents driving the particles deeper into the fiber. This applies to things as copier toner, gum, crayons, dirt, makeup, tar, etc. Always try to vacuum any loose residue off the surface before you apply vapor to it!


BACK TO How to Clean using Steam

google3c853d641db8f581.html